Abba's House LLC handles residential electrical work in New York. That covers outdated wiring, overloaded panels, new circuits, and lighting. Electrical upgrades get planned with the remodel, so walls are opened once and closed once.
Many New York homes still run on wiring installed decades ago. Two prong outlets and fuse boxes are common. So is 60 or 100 amp service, never sized for heat pumps, home offices, or car chargers. The warning signs are tripped breakers and warm outlets.
Electrical work is most efficient during a remodel. Abba's House LLC coordinates new circuits and fixtures with the carpentry, drywall, and painting schedule. That avoids cutting into finished walls later and keeps the job ready for inspection from rough in to final.
Electrical repair in New York covers dead outlets, tripping breakers, flickering lights, loose connections, and warm switches. Each problem is traced to its source in the circuit. Nothing gets replaced until the cause is clear, so the same fault does not return.
Get an estimate
Electrical rewiring in New York replaces knob and tube, cloth cable, and ungrounded circuits. These are common in older housing stock. Rewiring during a renovation is the cleanest approach. Walls and ceilings are open, so new runs go in without extra patching.
Get an estimate
Panel upgrades in New York replace fuse boxes and undersized breaker panels. The new service is sized for how the family uses the house today. That usually means room for kitchen circuits, laundry, air conditioning, heat pumps, and an electric vehicle charger.
Get an estimate
Lighting installation in New York includes recessed lights, ceiling fixtures, under cabinet lighting, porch and exterior lights, and dimmer controls. New lighting is laid out with the room plan. Switches land where people walk in, and fixtures clear cabinets, beams, and trim.
Get an estimateThe panel, the existing circuits, and the planned use of each room are reviewed before scope is written.
Rewiring, panel work, new circuits, and fixtures are listed in writing so the homeowner approves the exact scope.
New wiring goes in while the walls are open and is checked before insulation and drywall cover it.
Devices and fixtures are installed, every circuit is tested, and the panel is labeled before the job closes.
Electrical runs are laid out with framing and drywall. The walls in your home get opened once and closed once.
Older New York houses hide spliced circuits and brittle insulation. Each run is traced before it is reused or replaced.
Carpentry, drywall, painting, and electrical stay on one schedule, which keeps the job moving and keeps the homeowner fully informed.
A selection of electrical projects completed by our crew. Click the featured image to enlarge.
Watch for breakers that trip often, outlets that feel warm, flickering lights, two prong outlets, or an old fuse box. Older New York homes with original wiring are worth checking first.
Often, yes. It depends on your existing service and what the utility allows. We'll look at the panel and your load, then tell you if a panel or service upgrade is needed.
Usually, yes. With walls and ceilings already open, new wiring goes in faster and with far less patching. It also lets us place outlets and lighting around your new layout.
Yes. We'll walk through the house, check the panel and the rooms involved, then send you a written estimate. It's free, and there's no obligation to move forward with it.
Electrical repair, rewiring, panel upgrades, and lighting installation are available in these New York towns. Pick your town below or ask about one nearby.
Hudson, Catskill, Oneonta, Woodstock, Saugerties, Lake Katrine, Red Hook, Tivoli, Rhinebeck, Millbrook, Pine Plains, Millerton
Rensselaer County, Scotia
Arlington, Port Ewen, Highland, Marlboro, Milan, LaGrangeville, Wappingers Falls, Hopewell Junction, Fishkill, Cold Spring
Cornwall, Warwick, Goshen, Port Jervis, Peekskill, Nyack
